Find your parts diagram
Sticker on the pump body (the part with the basket), not on the motor. Motor labels from Century, A.O. Smith or Regal won't match parts.
Label on the side of the tank near the base. Size is in sq ft, e.g. 420 sq ft = C4030 or CCP420.
Rating plate inside the front access panel. Note the BTU and gas type (NG or LP).
Molded into the body or printed on top. Robotic cleaners: on the power supply.
Still not sure? Call (818) 818-6559 and we'll find it for you.
PCG 0.75 HP Booster Pump Motor for Polaris PB4-60 Pressure Cleaners | PCG-075B
Fits these models
Pickup, delivery and shipping times are estimates, not guarantees.
Couldn't load pickup availability
● 1 in stock30-day returns Secure checkout
Store Availability
Checking store stock…
Choose store pickup at checkout. Usually ready in 1–3 hours during store hours. Not at your store? We can transfer it there, usually in a couple of days.
Have a question about this part?
Ask about fit, specs or shipping and get an instant answer.
Goes with this part
CA P65 Warning: Cancer and reproductive harm. www.p65warnings.ca.gov
Other parts on the same Polaris PB4-60 3/4HP Booster Pump
Get your pressure-side cleaner moving again. The PCG-075B is a 0.75 HP replacement booster pump motor for pressure-side pool cleaner booster pumps - the motor that drives the extra water pressure a cleaner like the Polaris PB4-60 needs to sweep and bag debris. When the old motor is noisy, weak, or dead, a fresh 3/4 HP motor restores full cleaning power.
- Replacement 0.75 HP motor for pressure-side cleaner booster pumps.
- Commonly used on Polaris PB4-60 style booster pumps.
- Restores the water pressure your pressure-side cleaner needs to run properly.
- Shut off power at the breaker and disconnect the old booster pump.
- Remove the old motor from the pump wet end and transfer the seal and impeller as needed.
- Mount the new motor, wire it for your voltage, and reassemble the pump.
- Restore power and confirm the cleaner is getting strong, steady pressure.
Important: confirm the horsepower, voltage, shaft, and frame match your existing booster pump before installing. Professional installation is recommended.