Pentair Brass Junction Box Gasket

About this product

Description

A. THE FOLLOWING PREPARATORY STEPS MUST BE COMPLETED BY THE CERTIFIED ELECTRICIAN
BEFORE LIGHT IS INSTALLED - SEE FIGURE 1.
1. Ensure that the electrical system of your pool conforms with all requirements of the National Electrical Code (NEC),
and all local codes and ordinances. A licensed or certified electrician must install the electrical system to meet or
exceed those requirements before the Junction Box is installed. Some of the NEC requirements are listed below.
2. To be certain that the pool’s electrical system meets all applicable requirements, the electrician should
also consult the local building department.
3. Position Junction Box to meet National Electrical Code (NEC) requirements and to prevent hazard to personnel.

Highlights

4. The center conduit hub is provided with a strain relief for a cord size up to a 10/3 AWG cord. Use underwater lights
with water resistant cord only.
5. Three equipment grounding terminals are provided for internal grounding suitable for #16 AWG to #10 AWG wire.
One pressure wire grounding terminal is provided for a #8 AWG insulated copper bonding wire.
6. Install the Junction Box gasket between the Junction Box base and cover. Replace gasket if worn or damaged (P/N
79300600).
7. Plug any unused conduit hubs with the conduit plugs provided.

Features

OPERATING INSTRUCTIONS

SAFETY INSTRUCTIONS

Brand Information

Founded in 1966, Pentair has engineered water solutions to filter, clean and sanitize water to its purest state, while automation equipment makes it all easy to control from anywhere so that you can truly enjoy your pool and spa.

Visit Manufacturers Website

Pentair Brass Junction Box Gasket | 79300600