Zodiac Outdoor Cover Assembly | R0512500

Introduction 

Wiring to the AquaLink® RS Control System or PDA

1. Ensure that all power to the power pack and the controller is disconnected/turned off at the circuit breaker.
2. Remove the screws attaching the cover to the back plate and prop the cover up to expose the terminals NOTE: Be careful not to pull the ribbon cable that is connected to the Power Supply and the Cover.
3. Remove the whitecap covering the comms hole.
4. Thread the controller cable through the hole. A grommet may be necessary depending on the size of the cable being used.
5. Attach a cable tie to the controller cable as shown.
6. The Jandy® AquaLink RS or PDA and power pack use a four (4) wire connection to communicate and can be wired up to 500 feet apart. Any outdoor rated four-conductor cable, minimum 22 AWG, can be used. Locate the appropriate screw terminals on the circuit board and wire the power pack to the AquaLink RS or PDA red 4-pin terminal bar.