Superior Stainless Steel Submersible Water Pump 1/2 HP | 91592

Installation

1. Connect a hose to the pump Use either the supplied garden hose adapter or other hose fitting (sold separately)

2. Place the pump on a solid surface in at least 1" of water. Do not place the pump directly in mud, sand, silt or on rocky surfaces as these materials can clog or cause damage the

Operation

1. Connect the plug into a 120 volt AC grounded outlet. The use of a GFCI is strongly

2. The pump will not remove all It will drain water down to approximately 1/2" of the floor. Disconnect the pump from the power supply when the pump stops moving water.
3. Do not let the pump run dry. The pump depends on water for cooling and lubrication. Operating the pump without water may cause the motor to overheat or cause damage to internal parts. It may also shorten the life of your pump.
4. This pump is equipped with an anti-airlock A stream of water will emit from this hole when the pump is operating. This is a normal feature of this pump. The anti-airlock hole should be cleaned periodically to prevent the pump from becoming air locked.
5. Your pump motor is thermally It is not recommended for pumping liquids over 120° F (49° C). The thermal overload protector will automatically shut down the pump in an overheat situation. The pump will reset itself once the pump cools down. This overload is designed as a safety device and it will fail after repeated use. Normal operation is for fluids between 32° F & 120° F (0° C - 49° C).