Pentair Rainbow Bromine /Chlorine Replacement Saddle Tube Fitting | R172262

Exercise extreme caution when opening or servicing the feeder. Do not inhale fumes. Wear protective gear. Follow the manufacturer's suggestions for handling the chemical.

1. If below water level, close the control valve and drain any water in the feeder by removing the ¼" NPT plug in the bottom, or by opening the valve on the optional drain kit. After draining, reinstall the plug (use thread seal tape) or close the drain valve.

2. Remove the cap of the feeder and fill it with Trichlor or bromine tablets. For maximum dispensary rate use of 1" diameter tablets, 3" tablets produce less than 40% of 1" tablets.

3. Make sure the O-Ring is clean, lubricated with Lifeguard Silicone, and in place, replace the cap. Hand tightens only.

4. Turn on the pump and timer switches. Open the control valve to #5 for one minute; which will allow the feeder to fill with water. Adjust the control valve according to your pool's size. Larger numbers dispense more sanitizer. The water in a newly filled pool should be properly conditioned to ensure the maximum effectiveness of the Lifeguard Automatic Feeder. Consult your local pool dealer for water conditioning information in your area. Refer to the tablet container for recommended residual. It is recommended that the sanitizer level be checked daily for the first 5 days. Remember that on hot days higher water temperature or increased pool activity will cause your pool to use more sanitizer. When possible, increase the feed a day or two in advance.