Pentair GW9500 Kreepy Krauly Vacuum Skirt Great White | GW9508

1. Put both white seals in the oscillator; hold them in place.

2. Install the oscillator on the long gear shaft. Install the ratchet gear on the shaft so that the teeth engage the ratchet on the oscillator. Install the spring, ratchet drum, pinion gear (large gear first), and cam (gear end first) on the shaft (See Figure 19). Hold the gears on the shaft while installing them, and compress the clutch spring to allow assembly to slip into place between the posts (See Figure 19).

3. Install the long gear shaft and end blocks in the cleaning head with the large arm of the cam down (see Figure 20).

4. Reinstall the short gear shaft and two gears (See Figure 21); the small pinion gears and the shaft pin go on the side toward the

end of the cleaneraway from the oscillator box. Make sure that the gears engage the gears on the long gear shaft.

5. Install the oscillator chamber cap and clip it in place.

6. Install the rubber vacuum skirt on the cleaner with the word ‘OUTSIDE’ showing. Start at the large pin on the back of the cleaner head (see Figure 22) and work around the cleaner. Make sure the skirt is flush against the stop strips on the cleaner head (see Figure 23).

7. Turn the cleaner over. If you removed the bumper and brush ring, replace them now.

8. Install the lower body assembly in the shroud. Fasten the cleaning head in place with 4 screws (2 long, 2 short – see Figure 24).