Jandy, WaterColors, LED Color Pool Light, 120V, 50' Cord | CSHVRGBWS50

Installing the Light Fixture

NOTE Perform these steps only after the electrical system requirements are met.

1. Feed cord through conduit to junction box, leaving at least four (4) feet of cord at the light fixture to coil into the base of the light niche, see Figure 1. The four (4) feet of cord allows the light to be serviced after the pool is filled with water.

2. Cut the cord at the junction box, leaving at least six (6) inches of cord to make connections.
3. Strip six (6) inches of the outer cord jacket to expose the three insulated wires. Be careful not to damage the insulation on the three (3) inner wires.
4. Install strain relief over cord jacket and connect all three (3) wires to the corresponding circuit wires in the junction box. Install the junction box cover.
5. Coil the 4-foot length of cord around the fixture or into the base of the pool niche, and place the light assembly into the niche.
6. Engage the retainer tab on the bottom of the face ring, then pivot the top of the fixture inward and tighten the special pilot screw.

7. Fill the pool until the underwater light is completely submerged in water before operating the light for more than 2 minutes. The light will heat up quickly when operated outside of water. Turn on main switch or circuit breaker, and the switch, which operates the underwater light, to check for proper operation.