Jandy FloPro/ FHPM Pump Basket | R0480100

Lid with Locking Ring, Lid O-ring, and Basket

1. Refer to Figure and the associated parts list to identify the parts included in each replacement kit.

2. Comply with the warnings and follow Steps 1-3 in Section 2, Pump Disassembly.

3. Turn the lid's locking ring counter-clockwise until 'START' aligns with the ports. Carefully remove the lid and lid o-ring.
4 To avoid air leaks in the system, remove debris on the lid o-ring seat, lid o-ring groove, and sealing surface on the pump trap.

5. To replace lid with locking ring (R0480000) and lid o-ring (R0480200) only:
a. Clean the lid o-ring and place it in the lid groove.
b. Continue with Step 6 to replace debris basket or Step 7 to complete this procedure.

6. To replace pump debris trap basket (R0480100) only:
a. Lift the debris trap basket out of the pump.
b. To avoid air leaks in the system, remove all debris from the pump.
c. Place new pump basket in pump housing. Align basket slot with positioning tab inside pump body (See Figure 8.) If aligned properly, the basket will drop easily into place. Do not force it into place.
7. Place the lid on the pump housing. Align 'START' with the ports and turn the lid's locking ring clockwise until 'LOCKED' aligns with the ports. Hand-tighten the lid. Do not use any tools.
8. Return valves to the proper position for normal operation.
9. Open the filter pressure release valve and bleed all the air out of the filter.
10. Close the pressure release valve assembly.
11. Turn on the power to the pump and check the system for normal operation.