Find your parts diagram
Sticker on the pump body (the part with the basket), not on the motor. Motor labels from Century, A.O. Smith or Regal won't match parts.
Label on the side of the tank near the base. Size is in sq ft, e.g. 420 sq ft = C4030 or CCP420.
Rating plate inside the front access panel. Note the BTU and gas type (NG or LP).
Molded into the body or printed on top. Robotic cleaners: on the power supply.
Still not sure? Call (818) 818-6559 and we'll find it for you.
BWT Kokido PWRBLADE 92 Rechargeable Pool Vacuum
No hose.
No cord.
No leaves left.
The PWRBLADE 92 is a heavy-duty, battery-powered pool vacuum. Put it on a telescopic pole, switch it on, and its PWRBLADE impeller pulls leaves, debris and sand into a filter bag, with no hose, no pump and no cord.
Battery Powered, Water Activated
Cleaning Power That Starts on Its Own
A built-in rechargeable lithium-ion battery drives the impeller, so you never connect a hose to the skimmer or run your filter pump to vacuum. Turn the knob to on and lower the vacuum into the pool. Its water sensors detect the water and start the impeller within seconds, and it stops on its own shortly after you lift it out.
- Up to 75 minutes of cleaning on a full charge
- Charges in 5 to 6 hours. The adaptor light is red while charging and green when done.
- The impeller starts 4 to 5 seconds after the vacuum goes into the water
- It stops 2 to 3 seconds after you lift it out
- No hoses, no skimmer connection and no cords in the pool
Two Filter Bags Included
The Right Bag for Every Mess
The PWRBLADE 92 comes with two filter bags. Use the regular bag for leaves and larger debris, and switch to the fine bag when the floor is covered in sand and finer dirt. Each bag twist-locks onto the top of the vacuum, and debris goes in from the front, sides and back.
- Regular filter bag for leaves and larger debris
- Fine filter bag for sand and finer debris
- Twist-lock collar: line up the tab, then turn it clockwise to lock
- Press the cord fastener to release the bag for emptying
- Rinse the bag with water, or use only a soft brush if needed
PWRBLADE 92 Features
Every feature here comes straight from Kokido's PWRBLADE 92 user manual.
PWRBLADE Impeller
If too much debris jams the impeller, it stops automatically to protect the motor, and the indicator light turns red.
Status Light
A light on top shows when the vacuum is on, running, low on battery, out of charge or clogged.
Removable Extensions
Click the left and right side extensions on to clean wide areas, or take them off to get into narrow spots.
Brushes and Wheels
Brushes clip into the underside, and three wheels help the vacuum glide across the pool floor.
Telescopic Pole Connector
The spring-loaded pole connector takes a standard telescopic pole. The pole is not included.
Slatted Cover Compartments
Remove one extension to clean the sunken compartment of an automatic slatted pool cover. The compartment needs at least 12 in. (30 cm) of clearance.
Saltwater Ready
You can use it in saltwater pools. Just make sure all the salt has dissolved before the vacuum goes in.
Waterproof Charging Pins
The charging pins are waterproof. Rinse and dry the port after each use to keep them clean.
A Closer Look at the PWRBLADE 92
Real photos of the vacuum: the impeller, the underside, and the side with its rating label.

The PWRBLADE Impeller
The turquoise impeller sits inside the body and pulls water and debris up into the filter bag.

The Underside
The intake, brushes, wheels and translucent side extensions all sit on the underside.

Knob and Pole Connector
Turn the knob clockwise for on and counterclockwise for off. The off position also opens the charging port.
How to Use the PWRBLADE 92
Here is a full cleaning session, from the charger to the pool and back, based on Kokido's user manual.
-
Charge It
Turn the knob counterclockwise to off to open the charging port. Attach the charging plug, then connect the adaptor. Charge for 5 to 6 hours (about 6 hours the first time). The adaptor light turns from red to green when it is done.
-
Set It Up
Twist-lock the regular or fine filter bag onto the top, click on the side extensions if you need them, and slide a telescopic pole onto the pole connector until it locks onto the pins.
-
Switch On
At the side of the pool, turn the knob clockwise until it clicks. This exposes the water sensors, and the light turns blue.
-
Lower It In
Lower the vacuum all the way into the water. The light turns green, and the impeller starts after 4 to 5 seconds. The vacuum must be completely underwater to run.
-
Vacuum
Keep the vacuum flat on the floor and move it back and forth over the debris. If the light turns red, the impeller has stopped. Take the vacuum out, switch it off, and clear the impeller or empty the bag.
-
Lift Out and Rinse
Bring the vacuum to the side and flip it upside down before you lift it out, so debris stays in the bag. Empty the bag, rinse everything with fresh water, and dry the charging port.
After a session, let the vacuum rest for 30 to 40 minutes before you charge it again. Never leave the charging plug attached while the vacuum is in the water.
Know What It's Doing at a Glance
The status light on top of the PWRBLADE 92 shows you what the vacuum is doing, even from the pool deck.
Blue
Power on, ready to goBlue, Flashing
Battery is running lowGreen
Cleaning in progressGreen, Flashing
Battery is running lowOff
Battery depleted, needs a rechargeRed
Impeller stopped (clogged)Indicator meanings from the Kokido PWRBLADE 92 user manual.
Where the PWRBLADE 92 Shines
Leaf Season
Use the regular bag for leaves and larger debris, and keep vacuuming for up to 75 minutes per charge.
Slatted Cover Pools
With one extension removed, the vacuum fits down into the sunken compartment of an automatic slatted cover.
Steps, Ledges and Corners
There is no hose to drag around, so you can steer it into tight spots. Take the side extensions off for narrow areas.
Kokido PWRBLADE 92 Specifications
From Kokido's PWRBLADE 92 user manual and the rating label on the vacuum
PWRBLADE 92 Replacement Parts
Part numbers from the parts list in Kokido's EV092 user manual. Several parts are shared with Kokido's EV90 vacuums.
-
Regular Filter Bag
EV90-06R -
Fine Filter Bag
EV90-011 -
Brushes (Left and Right)
EV90-11 -
Wheel (x3)
EV90ASM03 -
Side Extensions
EV90ASM02 -
Wheel Bracket
EV90-01-001 -
Charging Plug
EV90-09 -
Adaptor (US)
EV90-08-002/US -
Telescopic Pole Connector (US/EU)
K969ASM06/PWR -
Main Unit (US)
EV092ASM01/US
Kokido PWRBLADE 92 FAQ
Quick answers about the PWRBLADE 92 rechargeable pool vacuum
No. It runs on its own built-in rechargeable battery and impeller. There is no hose to connect, and you don't need to run the pool pump. You only need a telescopic pole to steer it.
Kokido rates it for up to 75 minutes on a full charge. A heavily loaded filter bag works the motor harder and can shorten the runtime, so empty the bag regularly.
Charge it for 5 to 6 hours, and fully charge it (about 6 hours) before the first use. The adaptor light is red while charging and turns green when the battery is full. After cleaning, let the vacuum rest for 30 to 40 minutes before you charge it again.
No. The PWRBLADE 92 includes a spring-loaded pole connector that fits a standard telescopic pool pole, sold separately.
Use the regular filter bag for leaves and larger debris. Switch to the fine filter bag when the pool has sand and finer dirt. Both bags come in the box.
A red light means the impeller has stopped, usually because debris jammed it or the bag is full. Take the vacuum out of the water, turn the knob counterclockwise to switch it off, then clear the impeller or empty the bag. Turn it back on to keep cleaning.
Yes. The Kokido manual only asks that all the salt be fully dissolved before the vacuum goes into the water. Rinse the vacuum with fresh water after every use.
No. The PWRBLADE 92 is its own model (EV092) with its own main unit. Kokido's parts list shows that it shares some replacement parts with the EV90 family, including the regular (EV90-06R) and fine (EV90-011) filter bags.
Care and Storage for Your PWRBLADE 92
From the Kokido user manual
After Every Use
Rinse the vacuum with fresh water and don't use harsh detergents. Dry the charging port, pins and water sensors with a cotton swab. If stains form, a swab dipped in lemon juice or vinegar will remove them.
Off-Season Storage
Store the vacuum at 30 to 50% charge, and recharge it at least once every three months. Keep it somewhere dry and well ventilated at 50 to 77 °F (10 to 25 °C), away from sun, heat and pool chemicals.
Charging Safely
Use only the adaptor and charging plug that come with the vacuum, and plug the adaptor into a GFCI-protected outlet. Make sure the plug and port are clean and dry before you charge.
Battery
Never open the main unit or try to replace the impeller, motor or battery yourself. If the battery stops charging fully or the runtime drops noticeably, contact your dealer.
This is not a toy. Keep children away from the vacuum and its accessories, and only run it when it is fully underwater.
Los Angeles Local Installation Request
Need professional pool equipment installation in the Los Angeles, California area? We handle installation of heaters, pumps, filters, automation systems, and more. Fill out the form below, and we will contact you soon to schedule your local service!
What LA pool owners say about us
Google reviews of our 8 stores — our service and shopping experience, not reviews of this product.
