Pentair SpaBrite Spectrum AquaLight Wire Clamp | 79210400

F. Reassemble the fixture. See Figure 3.
1. Remove the gasket from the lens and install a new gasket, p/n 79108500, on the lens. A NEW LENS GASKET MUST BE USED EACH TIME THE LIGHT IS REASSEMBLED.
2. While holding the fixture upright, place the lens with gasket and face ring on top of the light shell. Align the pilot screw in the face ring with the arrow on the label marked "Arrow on this label must line up with the pilot screw on the face ring".
3. While holding the aligned face ring and shell together, turn the assembly upside down and set it on the old gasket, using the old gasket as an assembly fixture. This will keep the lens and gasket assembly from being pushed out of the face ring while you secure it to the light fixture. See Figure 4.
4. With the bent ends of the circular wire clamp pointing up, spread the clamp and place it in the "U" recesses of the face ring clips. Ensure that the bent ends of the clamp are located between the pair of clips as shown in Figure 3, location A. Check to see that the clamp is properly engaged with all of the clips.
5. Hold the ends of the wire clamp together. Insert the bolt through the open loop and thread it into the nut. Using a Phillips head screwdriver or a 3/8 in. hex nut driver, tighten the screw until the distance between the ends of the clamp equals ¼ inch or less. See Figure 4.
6. Discard the old gasket.