Pentair MasterTemp/Max-E-Therm Pool/Spa Heater Water Pressure Switch for 200K-400K BTU | 42001-0060S

$64.99
In stock
SKU
42001-0060S
- +
Ask a Question

Ask a Question

Pentair MasterTemp/Max-E-Therm Pool/Spa Heater Water Pressure Switch for 200K-400K BTU | 42001-0060S

SKU#: 42001-0060S

Water Pressure Switch for Pentair MasterTemp/Max-E-Therm Pool & Spa Heaters

$64.99

Ask a Question
Pentair MasterTemp/Max-E-Therm Pool/Spa Heater Water Pressure Switch for 200K-400K BTU | 42001-0060S
Pentair MasterTemp/Max-E-Therm Pool/Spa Heater Water Pressure Switch for 200K-400K BTU | 42001-0060S
  • Product Details

    About this product

    Description

    If the water flow is restricted, the water pressure switch may prevent the burner from firing and cause the “Service System” light to go on. If the light remains on after the filter has been serviced, have a qualified service technician check the system. For deck-level heater installations, the Water Pressure Switch is factory set at 3.00 psi (20.6 kPa). If the pressure switch is one feet (.3M) below or above the pool water level, reset the switch so that it is open when the pump is off and closed when the pump is running. Turn the star-wheel on the switch clockwise ( ) to raise setting (heater below the pool) and counterclockwise ( ) to lower the setting (heater above the pool) – see Test the switch after resetting. NOTICE: When the heater is mounted more than five feet (1.5M) above or four feet (1.2M) below the deck level, a Pressure Switch is no longer adequate. A Flow Switch must be installed instead. NOTICE: Heater operation with incorrect Pressure Switch setting may cause operation with no water flow. Operation of the heater without sufficient water flow may severely damage it.

    Highlights

     

    • Restricted water flow triggers the water pressure switch, stopping the burner and activating the "Service System" light.
    • After filter service, if the light remains on, a qualified technician should inspect the system.
    • For deck-level heater installations, the Water Pressure Switch is factory set at 3.00 psi (20.6 kPa).
    • To reset the switch if it's positioned more than one foot (.3M) below or above the pool water level, ensure it's open when the pump is off and closed when the pump is running. Adjust by turning the star-wheel clockwise (raise setting) or counterclockwise (lower setting).

     

    Features

    Brand Information

    Founded in 1966, Pentair has engineered water solutions to filter, clean and sanitize water to its purest state, while automation equipment makes it all easy to control from anywhere so that you can truly enjoy your pool and spa.

    Visit Manufacturers Website
  • Q/A
    No Questions
WARNING! The following product(s) can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov