CMP Snap-Lock Wall Fitting | 25505-000-000

$18.99
In stock
SKU
25505-000-000
- +
Ask a Question

Ask a Question

CMP Snap-Lock Wall Fitting | 25505-000-000

SKU#: 25505-000-000

CMP suction side seftali Snap-Lock Wall Fitting 1-1/2 AMP treading

 

$18.99

Installation
1. Thread the fitting into a 1-1/2" NPT suction port in the pool wall. Make sure that you end with the cover spring as close to 12 o'clock as possible .
NOTE: This fitting is designed for a threaded pipe connection only. Do not attempt to bond the fitting in place.
2. When the fitting is tight and the spring in the 12 o'clock posi-tion, tighten the set screw (included) to hold it in place (see
Figure 1B).
3. Open the door with a key or coin. Insert the hose so that the grooves in the hose interlock with the tab on the vac-port door . This will prevent the hose from squirting out of the fitting when the pump is stopped.

Ask a Question
CMP Snap-Lock Wall Fitting | 25505-000-000 CMP Snap-Lock Wall Fitting | 25505-000-000 CMP Snap-Lock Wall Fitting | 25505-000-000 CMP Snap-Lock Wall Fitting | 25505-000-000
CMP Snap-Lock Wall Fitting | 25505-000-000
  • Product Details

    About this product

    Description

    NOTE the following:
    • Only open the door when the pump/filter system is off. A key or coin is required. You will not be able to open the door when the pump/filter system is operating.
    • The pump may cavitate (causing damage to the pump) if the hose is removed and the vac-port is allowed to shut with no other suction sources open. Do not remove the hose from the vac-port unless another source of suction is open.
    It is good practice to remove the vac-port and plug the open port in the pool wall when closing the pool for the season.
    • This fitting is NSF Listed to the IAPMO 4-99A Special Use
    Suction Fitting Standard.

    Highlights

    Easy installation

    Suitable for CMP Suction Pool Cleaners

    Unique pin for securing the hose

    Features

    Installation
    1. Thread the fitting into a 1-1/2" NPT suction port in the pool wall. Make sure that you end with the cover spring as close to 12 o'clock as possible .
    NOTE: This fitting is designed for a threaded pipe connection only. Do not attempt to bond the fitting in place.
    2. When the fitting is tight and the spring in the 12 o'clock posi-tion, tighten the set screw (included) to hold it in place (see
    Figure 1B).
    3. Open the door with a key or coin. Insert the hose so that the grooves in the hose interlock with the tab on the vac-port door . This will prevent the hose from squirting out of the fitting when the pump is stopped.

    Brand Information

    CMP is a leader in products for the recreational pool and spa industry. Innovative products from CMP include sanitizer systems, white goods, LED lighting, water features and accessories. CMP is committed to creating solutions for pool and spa industry professionals. Spa designers, pool builders, bath manufacturers and retail store owners around the world depend on CMP products, service and support.

    Visit Manufacturers Website
  • Q/A
    No Questions
WARNING! The following product(s) can expose you to chemicals which are known to the State of California to cause cancer and birth defects or other reproductive harm. For more information go to www.p65warnings.ca.gov